![]()
Picture 3.2 - IP Address Configuration for Management Interface Eth0Ĭonfigure the interface used for connection to the Internet (Picture 3.3). Configure the IP settings for management interface (Picture 3.2). Picture 3.1 - R80.10 First Time Configuration WizardĬlick Next and select the option Continue with R80.10 configuration. Now you should be able to load first Time Checkpoint Configuration Wizard with your web browser (Picture 3.1). Gw-123456> the following command from Expert mode to CLI of the affected machine and then reload the Gaia Portal login page ( Reference). #INSTALL CHECKPOINT GAIA VIRTUALBOX IMAGES PASSWORD#However, you need to configure the password for expert mode first: If Gaia portal shows blank page after log in with Firefox 5x or Chrome 66 then login to Gaia CLI and enter expert mode. Use Internet browser to connect to the Gaia web portal. Note: Check if corresponding interfaces are create to the bridges br0 and br2 with the command brctl show. Note: You must specify the option -smp 2 otherwise Gaia installation fails. $ sudo /usr/local/bin/qemu-system-x86_64 -m 4096M -enable-kvm checkpoint.img \ Running the First Time Checkpoint Configuration Wizard Once you are asked for reboot of the system, close the Qemu window.ģ. netdev tap,id=net2,ifname=tap2,script=no,downscript=no \ netdev tap,id=net1,ifname=tap1,script=no,downscript=no \ netdev tap,id=net0,ifname=tap0,script=no,downscript=no \ boot d -cdrom Check_Point_R80.10_T462_Gaia.iso checkpoint.img \ $ sudo /usr/local/bin/qemu-system-x86_64 -m 4096M -enable-kvm -smp 2 \ #INSTALL CHECKPOINT GAIA VIRTUALBOX IMAGES ISO#$ /usr/local/bin/qemu-img create -f qcow2 checkpoint.img 100GĪs we downloaded Gaia ISO image in the part1 of the tutorial, we can start Checkpoint Gaia VM machine with the ISO attached to Qemu cdrom. #INSTALL CHECKPOINT GAIA VIRTUALBOX IMAGES INSTALL#Let's start with the point 2.įirst, we need to create an empty qcow VM disk with qemu-img utility as we want to install Gaia into this image. We will use the same network topology depicted on the Picture 1.1 of the part 1. ![]() Let' assume that we have created underlying network infrastructure with the scripts create_taps.sh and bridge_interfaces.sh in Part1. This part goes further and explains Gaia installation on QEMU virtual machine (VM).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |